- #AEON LABS Z STICK ADD DEVICE SERIAL#
- #AEON LABS Z STICK ADD DEVICE UPDATE#
- #AEON LABS Z STICK ADD DEVICE MANUAL#
- #AEON LABS Z STICK ADD DEVICE SOFTWARE#
Name the device so that you can easily find it later, when you are done, click on "Add Device"Ĥ. Once you click on the green arrow, a popup will appear. You will see a list of available devices and some of their status.Īny green arrow is what you would click on to activate as an active device in your network.ģ. When you finally want to add some control into your network, and have finished adding or configuring your devices, go to:Ģ.
#AEON LABS Z STICK ADD DEVICE MANUAL#
(if tapping the button doesn't work, make sure to read the manual of the Z-Wave Device that you are attempting to pair to determine the special button press for pairing/inclusion).Ĥ) Adding control to your paired Z-Wave devices.
You will also notice a new device at the bottom of the list. Tap the button on Z-Wave device to complete pairing, if successful, the popup message should disappear. You should notice a popup that says "please press the inclusion button on your device" (if tapping the button doesn't work, make sure to read the manual of the Z-Wave Device that you are attempting to pair to determine the special button press for unpairing/exclusion/removal).
#AEON LABS Z STICK ADD DEVICE UPDATE#
If you find that Domoticz is not updating newly adopted devices at all after re-connecting with the Z-Stick Gen5 at the start, try disabling then re-enabling the Z-Stick from the Hardware page which should effectively re-connect and update your device list almost immediately.
#AEON LABS Z STICK ADD DEVICE SERIAL#
If you are having issues connecting Z-Stick Gen5 to Domoticz, make sure you are selecting the correct COM port, for Windows, you would use "Device Manager" which Z-Stick Gen5 should show up as a "USB Serial Device (COMX)." From this page you can see if there are any errors or if you would need to re-install drivers. All devices already added to Z-Stick Gen5 should appear in the list of devicesĢ.1) Having issues connecting Z-Stick to Domoticz or having issues viewing newly paired devices directly from your Z-Stick Gen5:ġ. (for example, mine shows up as COM3)ĥ.To see your network, click on "Setup" where the arrow is pointing to in the above pictureĦ. Serial Port: the Z-Stick Gen5 COM port will appear here. Go to "Setup -> Hardware" at the top right tabģ.